A Set of 20 Good Quality Closed End Replacement Wheel Nuts for Alloy & Steel Wheels
This ad is for a set of 20 wheel nuts
Technical Specification
Chrome Plated, M12x1.5mm Thread, 31mm Deep with closed end, 60 degree Tapered Seat & Uses a (19mm Hexagon) Socket/Wrench
Important Information
Always compare the seating and thread with the original equipment fitted, The Manufacturer Strongly recommends that each installation should be inspected during fitment and thoroughly checked after fitment (by spinning the wheel if necessary) after 200 miles or 300km use. Torque settings should be in accordance with vehicle manufacturers recommendations. If you are unsure about any aspect of fitting do not attempt to fit but contact your local dealer. Your wheel hubs or brakes may be adversely affected by wrongly fitted wheel nuts. Do not use air guns to fit.
These nuts are specified to fit the vehicle shown in the compatibility table, please note they are specified for OE (original equipment) not aftermarket wheels. If your vehicle has aftermarket wheels fitted you should seek advice from the wheel manufacturer to ensure you have the correct seating.
Fitment – All data in this ad is taken via third party databases, the company
makes every effort to ensure the listings are accurate but responsibility will
not be accepted for errors or omissions with-in the listings. You should always
check the product being fitted against the part being removed and check that
they are of the same specification, if you are unsure you should consult your
vehicle dealership for advice. “The Business Seller” cannot be held responsible for any
consequential loss or damage caused by the incorrect fitting of a part or
fitting a part that is not suitable for the vehicle application– If you are unsure you should always seek
the advise and opinion of a qualified vehicle mechanic.Any purchase made through this ad constitutes
the acceptance of these terms and conditions.