AU TURBO

P/N: AUT-TRB-KIT-13B-RX7FB-ST-IC-BLS

Product Overview

Below are the specifications for the Turbo Kit.

Single Turbo + Intercooler Kit For 1978-1985 Mazda RX-7 SA/FA/FB Series 1, 2, 3 With FC/FD 13B Turbo Motor Swap, Upgrade Single Top Mount Turbo.

  • Turbo Kit:
    11 Gauge Thick Wall Manifold
    T4 Flange, 60mm Vband Wastegate Flange (NOTE (*): the flange does not come welded to the manifold).
    T72 Turbo with 0.81 AR Exhaust Housing, Good For 500 HP
    60mm Vband Wastegate
    3" Stainless Downpipe, It Ends Close To Transmission End, You Will Need to Finish the Rest of the Exhaust System
    Oil Line and Fitting Kit
  • Intercooler:
    25x11.75x3 inch Overall Size
    3" Inlet and outlet
  • Intercooler Piping Kit:
    3" Aluminum Pipes with Blue Hoses
    50mm BOV

    Compatibility:

  • Chassis: 1978-1985 Mazda RX-7 SA/FB
  • Engine: 13B Turbo Motor From FC Or FD (With Original 12A Front Cover)
  • These Are Brand New Developments By AUTURBO, Upgrade Stock 13B Twin Turbo to Single Top Mount Turbo, Dramatically Increase Performance, And Offer Beautiful Professional Looks.

    Items included in this listing:

  • Thick Wall Manifold + T72 Turbo + 60mm Wastegate + Downpipe + Turbo Oil Line Kit + Intercooler Kit
  • Note: Radiator, Oil Cooler, Gilmer Drive Pulley Shown On Installed Pictures Are NOT Included. Check Our Other eBay Listing If You Want Them.

    Note:

  • 1. This Is For Single Turbo Upgrade, Does NOT Fit Stock Twin Turbo. Due to Change of Turbo Setup, You Will Need to Re-Tune Your Car.
  • 2. This Kit Is Developed Based On Left-Hand-Drive Chassis, For Right-Hand-Drive Chassis, We Have Not Tested and It Probably Will Hit Steering Shaft.
  • 3. Downpipe Ends with 3" Vband, It Does NOT Fit ANY Exhaust System, You Will Need To Build or Fix The Rest Of the Exhaust System.
  • 4. Need to Drill Two 3.25-3.5" Holes On Both Side of the Radiator Support to Run Intercooler Piping.
  • 5. (*): The flange does not come welded onto the manifold as depicted in the picture and should be attached afterwards for the correct angle and fitting.
  • 6. No Installation Instruction Is Included, This Kit Is For Advanced User Who Knows What to Do.

Photo Gallery

Need to Drill Two 3.25-3.5" Holes On Both Side of the Radiator Support to Run Intercooler Piping.