VALIANT AP6 VC VE VF VG VH VJ VK CL CM DRAG SHOCKERS FRONT & REAR COMP ENG

Valiant RV1 SV1 AP5 AP6 VC VE VF VG VH VJ VK CL CM
Competition Engineering Drag Race Adjustable
Front & Rear Shock Absorber Set

Please note these are not a replacement part specifically designed for this particular application. Please refer to the measurements listed below to ensure correct fitment. These are not suitable for vehicles with very low ride heights.

Front
Competition Engineering Extended length - 428mm (original length 394mm)
Competition Engineering Compressed length - 264mm  (original length 244mm)

Upper Mount – Stud
Lower Mount - Ferrule with sleeved bush

Rear
Competition Engineering Extended length - 600mm (original length 575mm)
Competition Engineering Compressed length - 359mm  (original length 346mm)

Upper Mount – Ferrule
Lower Mount – Ferrule

Includes Bushes, Washers, Sleeves And Nuts For All 4 Shockers

These Competition Engineering adjustable drag shocks offer a 3-way valving system to dial-in the extension/compression ratio needed for any track condition. The front shocks have three adjustable ratios of 90/10, 80/20, and 60/40. The ratios for the rear shocks are 70/30, 60/40, and 50/50. These numbers represent the percentage of force required to extend (first number) and compress (second number) the shock. By changing the settings on the front and rear shocks, you can dial-in the car to raise the front on initial launch for weight transfer, and then settle smoothly for a final charge to the finish line.

You can quickly change the valve setting by simply compressing the shock fully and rotating the shaft until the indexing notch mates with the desired setting on the body. It's as simple as twist and click.