3D printed saddle, carriage cradle.
Primos 2 owners please be aware,
the thread on top of the stick is spring loaded & when pushed down reveals a smaller thread which fits to the joint.
Before you read the text below, this clamp has been designed by a toolroom engineer.
The clamp has had 12 months+ of design & investment to make sure that it meets all of your requirements.
If it doesn't, please return for credit (no questions).
Designed by a shooter for shooters.
Cradle slide is spring loaded,screws in & out, & fits to a standard tripod with the nut inserted, so anything with that fitting.
Or any stick with a 1/4 unc 20 tpi screw
Amount of movement is 27 mm upto 70 mm gap
V-Tenons are strengthened with 2x 4mm steel pins in each leg.
Sides & base are covered with a 3 mm neoprene rubber to protect your gun..
Most suited to pcp air guns.
Side plates are 14 mm thick excluding neoprene.
3d printed thumb turn with 8 x 1.25 steel stud + protective thread end cap.
Please do not hesitate to contact me, if you have any questions.
Approximate overall dimensions are 90mm long * 85mm deep * 100mm for cradle + thumb turn.
Developement work on this has been quite extensive.
Tripod is not included in the price
N.B Your tripod must be of a good quality to avoid excessive wobble.
Made in the England
The pictures show the latest version.