Fit All the following Dodge Models with Factory Fitted Alloy & Steel Wheels

Dodge Avenger from 2008 to 2011

Dodge Caliber from 2006 to 2011

Dodge Journey from 2008 to 2011

This Ad is for a Single Nut

Technical Specification

Chrome Plated, 12x1.5mm Thread, 31mm Deep with closed end, Taper Seat & Uses a 19mm Socket/Wrench

Important Information

Always compare the seating and thread with the original equipment fitted, The Manufacturer Strongly recommends that each installation should be inspected during fitment and thoroughly checked after fitment (by spinning the wheel if necessary) after 200 miles or 300km use. Torque settings should be in accordance with vehicle manufacturers recommendations. If you are unsure about any aspect of fitting do not attempt to fit but contact your local dealer. Your wheel hubs or brakes may be adversely affected by wrongly fitted wheel nuts. Do not use air guns to fit.