Fitment Details/Instruction
Fitment is very straightforward and simple to carry out, please see the steps below: -
- Remove OEM venting from appropriate location.
- Insert instrument gauge of your choice into your new vent pod. (e.g. temp, pressure gauge etc)
- Carry out any wiring work required on the vehicle to the gauges.
- Slide gauge into place, installation complete.
Some
owners may opt to cut the airflow off for the particular area where the
gauge pod is installed. You are welcome to do so however this is by no
means a requirement and keeping heat flow is one of the main design features of this particular product!
Customisation
Please
message us if you wish to customise your gauge pod - all of our orders
are sent in a Matte Black coating unless requested, which is a superb
match for the OEM look/feel. We have a wide range of base material
colours available including the following: -
- Black
- Gold
- Aquamarine Blue
- Orange
- Semi-Transparent (Clear)
- Red
- Carbon Fibre ** INCREASED CHARGE FOR THIS BLEND **
Product comes with 1 Year Warranty.
*Please
be aware, due to the item being made using FDM printing, small layer
lines may be visible in some areas. We try our best to cover these up
during the painting process, however, sometimes they may be visible upon
very close inspection. They are nothing to be worried about and do not
hinder the functionality of the product whatsoever, it is just where the
filament has bonded together layer by layer.