SM3268 basically does not support flash memory above 30NM, the old flash memory should use 3267 as much as possible!
BGA316 default BGA pad has been brushed
Special reminder because it is a single-paste 8CE version 64P master, which supports more than 8CE flash memory.
By default, shorting R44 supports 3D mode, ordinary films need to go to R44 and short R43.
!! After receiving the board, insert it into the computer without soldering, and the disk that can be seen in the disk management is a good board! Or under the mass production tool, after entering or leaving the U disk, the word “No Disk” appears on the page of the mass production tool, which is a good board!
Many people often ask me what chip I support, or send a picture to ask whether it supports it. I want to say that there are too many kinds of mobile phone chips, and there are all kinds of models. We ca n’t use them all, but I can tell you a little trick, you can disassemble them for comparison. The pictures in the details, if the feet are not right, it is definitely impossible! The quantity is small, we do not give mass production tools and too much technical support. There are too many reasons for failure. We can only prove that our board is good.
This is a U disk main control board. There is no capacity. The capacity depends on the capacity of the chip you are pasting. The above capacity is required.