![](https://www.mzfort.com/tippo/images/tippo_spc.jpg)
- Condition: 100% new
- Color:Silver
- Material: Metal & Plastic
- Input Power: DC9V--24V
- Standby Current: 6mA (DC12V)
- Output: Relay (Approved Current 20A)
- Fingerprint Capacity: 150 Or 300 Pieces
- Item included:
1 x K216 Fingerprint Control Board
1 x R503 Fingerprint Module
1 x Remote Control
- Compatible With: fit for all car
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
![](https://www.mzfort.com/tippo/images/tippo_des.jpg)
Feature:
1) 100% new and high quality.
2) Perfect match for the original equipment.
3) Control the relay by fingerprint or remote control password.
4) It can be used in automobile ignition control, elevator control, access control and other occasions.
Instructions for the Control Board:
1) Short press the setting button, when the light flashes quickly, you can register your fingerprints. Hold your finger and keep it still. When you hear the music, the fingerprint registration is successful. It can be registered continuously. If you don't register for 8 seconds, you will exit the registration state. (Key registration can only register 50 or 100 fingerprints, the registered fingerprints are stored in area 01)
2) Long press the setting button to hear long and music sounds, the initialization is successful, and the factory settings are restored.
3) Use: When the function setting selects 2, after the fingerprint passes, the relay closes for 5 seconds (default); when selects 1, the relay closes after the fingerprint passes, and the relay is released when the finger is removed.
Infrared Keyboard Remote Control Instructions:
1) Modify password: *password*1*new password*newpassword#
2) Register fingerprint: *password*2*DD#; DD starts from 00-02, a total of 3 fingerprint banks, each bank can store 50 or 100 fingerprints; exit registration button, or automatically exit after 10 seconds
3) Clear: *Password*3*Password#
4) Relay closing time: *password*5*SS #; SS is from 00-20, which is the relay closing time, from 0.5 to 20 seconds, 00 represents 0.5 seconds, and the default is 5 seconds. For example, set 1 second: *123456*5*01#
5) Delete fingerprint: *Password*6*DD#: DD starts from 00-02, a total of 3 fingerprint libraries.
6) Password usage: *Password: the relay is closed, press #: the relay is released.
7) Control working mode:
-Press *password*4*00# to turn on the fingerprint module touch standby
-Press *PASSWORD*4*01# to turn off the fingerprint module and touch standby (constant light mode)
Remarks: The red light means entering the programming state, the sound of music means the operation is successful, the default password: 123456, the password length is 6 digits
![](https://www.mzfort.com/tippo/images/tippo_car_hmain.jpg)