ADXL345 V1.0, it is a nozzle three-axis accelerometer board made for 36 stepper motor extruders, which can be connected to the main board through the ZH1.5 6Pin socket.

Only supports Klipper firmware.

Features:

1. One end of ADXL345 V1.0 cable adopts ZH1.5 6Pin plug, and the other end adopts 2.54mm 6*1Pin DuPont plug 70cm. This facilitates compatibility with motherboards that do not have ADXL345 sockets. And the wire is 70cm, which is convenient for users to DIY.

2. It can be directly installed on the 36 stepper motor, which is convenient to fix.

3. Using SPI communication, it can be directly connected to the main board 5V power supply.

4. ADXL345 is a 3-axis accelerometer with optional measurement range of ±2 g, ±4 g, ±8 g or ±16 g, 13-bit resolution. Both dynamic acceleration due to motion or shock can be measured, as well as static acceleration. Gravitational acceleration, for example, enables the device to be used as a tilt sensor.

Precautions:

1. The ADXL345BCCZ three-axis accelerometer needs to have a solid installation plane, otherwise it will affect its measurement accuracy.

2. Note that the board is powered by 5V, and 5V and GND cannot be reversely connected.