Specifications:
Voltage: DC12V
Light Source: 126 LEDs
Color: red
Length:approx 90cm/35inch
Fitment:for all most Cars
Waterproof: Yes
Functions: Brake + DRL Drive light+ Turn Signal(Left+right)+Hazard warning
LED Type: 5050 LED
With Flowing, Flashing, Sequential Modes
Type:Multiple Modes Car hight mount third Brake Light strip
Product name:Car led brake light
Attention: if you want to check the lights how to work. please contact us and tell us your email, we will send you a video for check.
4 Functions:
Running mode, all LED light up with sporty blink (low beam)
Brake mode, all LED light up (high beam)
Turn mode, flow sequential LED light up
Hazard warning flash mode, LED light up and spread from the center to the both sides
Feature:
1.Waterproof and durable soft silicone body
2.High-brightness LED lamp bead brightness high and low light decay life long durable
3.Intelligent decoder can be used directly by wiring, saving time,Lower power consumption,bulit in fuse.
4.The wire ends are designed with pins, without breaking the original power supply for non-destructive installation.
Note:
Please also measure your rear window size before buy this product. This item is approx 90cm/35inch.
How to Install:
1.Please use detergent or alcohol to clean the surface of the target area before stick it on.
2. Use the hair dryer to heat the tape a little.
3.Stick it on and keep your car non-washed. within 48 hours to achieve the best adhesiveness.
4.Try to finish the steps one time, do not peel off from one area and stick on another area to avoid bad adhesiveness.