■This is a cut kit for Canon Demi that has been replaced with a light seal inside the back lid.
If the light seal of the inner lid and mirror holder is worn out or sticky, you can easily replace it with this cut kit. Can be used safely without light leakage and rattling of the lid.
1. Peel all the old seals with an attached bamboo skewer, and clean them with benzine or alcohol. It is also very effective to apply a thin layer of adhesive to the blue area with a cotton swab.
2. Apply plenty of alcohol or water to the adhesive surface of the seal. While the adhesive surface is wet with alcohol or water, the adhesive strength of the tape will decrease, making it easier to align and reattach.
3. Set the position from the finder hole, and attach the seal to the corner with the arrow.
4. Please stick the rounded corner part while pressing it with your finger. It's easier if you can do it before the alcohol dries.
5. Similarly, apply alcohol or water to the tape surface.
6. I'll stick it to the groove.
7.8. Use a flat-blade screwdriver or a bamboo skewer to push in the narrow groove where your fingers cannot fit.
9. I don't think you need to put alcohol on this part. All you have to do is align and stick it.