12mm Hub 15mm Extension Adapter x 4

 

This will fit some 1/10 models. Please check measurements below before ordering as this will not fit all.

 

Simply replaces the normal 12mm hubs with these extensions. Great if intending to put larger wider wheels on or if simply needing to push the wheels away from the chassis.

 

How to check if this will fit?

 

1) Simply check all 4 wheels use a 12mm hub already.

2) The axle is 4mm in diameter

3) A 4mm nut was originally used to secure the wheel in place (this will no longer be needed).

4) The hole in the axle is 2mm (if no hole these wont be suitable). The hole should be on the smooth section of axle before the threaded section.

 

How to install?

These slot onto a 4mm axle and then are secured in place by a 2mm pin (included). Slot the wheel into place. The silver bolt pictured then screws into the hub and onto the 4mm axle (in place of the m4 nut originally previously used).

 

Whats in the pack and measurements?

4 x 12mm extension hubs:

 - 15mm long extension (measured end to end)

 - 5mm center hole for a 5mm silver bolt. 4mm threaded hole in the center for 4mm axles.

 

4 x 2mm x 10mm pins

 

Note: These are not suitable for 2WD models. These will not replace bearings. For these to fit your model must already use 12mm hubs and have a 2mm hole in a 4mm diameter axle.

 

Material: Alloy

Colour: Please select option at checkout.