About Product:Material: plastics + stainless steel (not full metal)
Features:
1. Made of fine quality material, durable to use.
2. It can help you repair the teeth on your car.
3. It will not harm the painted surfaces.
4. Suitable for processing sheet metal of car, refrigerator, motorcycle, washing machine, etc.
kit 1
Package included:
20x blue guides
1x gold extractor
2x spade blade
1x towel
1x instruction
Kit 2
Package included
1x stainless steel hammer
10x pounding pen
Kit 3
Package included:
7 x pulling bridge set
Kit 4(58 Pcs)
Package included:
12x red tabs
28x blue tabs
1x gold extractor
2x shovel
1x glue gun (plug usa/ue, 20w)
5x white glue stick (7*270mm)
5x yellow glue sticks(7*270mm)
1x towel towel
1x bottle of alcohol (alcohol not included)
1x tool bag
1x instruction
Kit 5(76 Pcs)
Package included:
12x red tabs
28x blue tabs
1x gold extractor
2x spade paddle
1x glue gun (plug usa/ue, 20w)
5x white glue stick (7*270mm)
5x yellow glue sticks(7*270mm)
1x towel towel
1x bottle of alcohol (alcohol not included)
1x stainless steel hammer
10x pounding pen
1x tool bag
1x instruction
7 x pulling bridge set
Warmly Note:
1. You can choose the right set according to your actual needs, there are some are some parts can be additionally purchased
2. More specific instructions for the use of instructions, you can also refer to the picture to buy, please rest assured that the purchase
How to use the tools?(As an example)
1. wipe the surface of the damage with a clean wet cloth;
2. place the gun glue stick and connect the power supply and preheat for 5-10 minutes;
3. pull the trigger and apply the appropriate design gasket with extruded glue (the 4 holes of the gasket should be applied with hot glue from the melt);)(note: the larger the design gasket, the greater the pulling force);
4. immediately place the design gasket with hot melt glue in the center of the tooth and hold until the sticks (let the glue cool for about 5-8 minutes. Cooling time should be less than 10 minutes and should be slightly shorter in winter);
5. align the t-shaped repairer and press the design joint with hot melt glue, pull the sliding rod back to pull the tooth;
6. when the tooth was removed, clean the glue by alcohol with plastic shovel;
7. if the tooth still exists, tap it gently with a tapdown hammer
8. repeat the above operation steps until the tooth is repaired.
Note: If the operation would not succeed,please operate repeatedly.
1.Select a suitable gasket and then apply glue to the drawing gasket with glue gun.
2.Fast place the drawing gasket,press lightly until the glue cures and adheres(let the glue cool for about 5 minutes).
3.Mount our puller and pull up the dent until the dent disappears.
4.Spray some alcohol and clean the repaired place with a plastic spatula.
Contact Us:
It would be highly appreciated if you might contact us first once you have any problems concerning the items. And you can expect all the issues would be resolved ASAP!