Specification:
This product is a miniature portable permanent magnet brushless AC/DC hydraulic generator set.
Requirements for use: 
the height of water drop is 5-30 meters,
Flow 0.007-0.25 cubic meters per second (or 50 caliber water flow)
Both conditions are met, The power will reach 1000W.

The generator is a permanent magnet brushless motor,
The motor coil is copper wire,
Rated power 300W,
Rated voltage 220V,
Under the premise of certain hydraulic conditions and rotational speed, the output voltage is about 220V AC/DC voltage,
It is suitable for pure resistance electrical appliances such as outdoor lighting, mobile phone charging, monitoring, low-power LCD TV and so on.
Electric appliances with motors, such as electric fans, refrigerators, washing machines, and air conditioners, are not allowed.

Kind tip:
The installation of the hydroelectric generator power will reach 1000W must meet the required two conditions of water drop height and water flow. The parameters can be used normally only when the parameters are met at the same time!
If any one of the water drop height and water flow rate is not met, The power will not reach 1000W!
(For example: the water flow is greater than the required flow but the water head cannot meet the requirements;
Or the water head is greater than the required water head but the water flow cannot reach both of these cases can not be used!
Both conditions must be met for 1000W!
On the premise that the water flow is satisfied,
The greater the height of the water drop, the greater the actual power generated, but generally not greater than the rated power. 
The portable hydro-generator set requires a water drop height of 5-30 meters.
Flow 0.007-0.25 cubic meters per second (or 50 caliber water flow)
The appearance and color of the generator set are basically as shown in the picture,
The appearance and color of the generator set may be slightly different due to different batches.
The customer is subject to the actual product received, and the power marked by the generator set is the rated power.

The impeller is fixed with a special fixed shaft and nut, and there is no need to add additional brackets and bearings for auxiliary fixing, and the design is more professional. (Note: The added bearing of the water-passing part is easy to damage)
The spacing between the impeller and the water hood is widened, the tail water is discharged more smoothly, and the resistance generated by the tail water is smaller and the design is more scientific.

Note:
Photo color might be a little different from the actual product due to color display of different monitors.

Packing Included:
1 x 1000W Micro Hydro Generator(installation requirements: water drop height of 5-30 meters.
Flow 0.007-0.25 cubic meters per second)