IMPROVED RENAULT REAR ABS BRAKE SENSOR HOLDER PLATE  

40mm inner diameter hole.

SIMPTOMS FOR REPLACAMENT

ABS light on dashboard, rusted or disintegrated ABS plate, ABS sensor hanging loose. Sometimes the plate is rusted away to the point where it is completely missing. This will allow the sensor to sit in the right place to detect the magnetic ABS ring. 

THE PROBLEM

It is very common for ABS plates to rust away, disconnecting it from the ABS sensor. The ABS plates that sit over the wheel hub corrode and disintegrate over time, thus reducing the connectivity to the ABS sensor and generating an ABS fault code. These plates are not available to buy separately as they are built into the rear axle and Renault garages will charge over £1000 for a new axle plus labor. Even scrap yards are not willing to sell the plates separately as they can make more money selling the complete axles and it is hard to find ABS plate in good condition.

OUR SOLUTION

·       Install our replacement improved design ABS plate to last the lifetime of the vehicle

·       Our own design ABS plates are a much more cost-effective solution to this common and simple issue.

·       Constructed of zinc-plated steel to prevent any corrosion, be wary of other sellers, as these will only fail again.

·       The brackets are a simple press fit on to the shaft.

FITS THESE MODELS

Centre diameter 40mm:

·       Renault Megane MK2 II (2002-2009) (Convertible, Estate, Hatch)

·       Renault Scenic MK2 II (2002-2009) (not Grand Scenic)

Associated part numbers:

7701477073, 7701477075

To be sure of compatibility check size- will fit models with a 30 or 32mm nut retaining the brake disc. The centre diameter of this piece is 40mm to fit 40mm shaft.

Please note there are two sizes of ABS plates available (40mm & 45mm). If you cannot see your vehicle listed above it is likely you need the 45mm. If unsure, please contact us to find out which size your vehicle needs.

YOU WILL RECEIVE

1 x ABS plate with 40mm centre bore.

Please note: Two are required if you need the part for both sides of rear beam.