1
x Rear Stub Axle ABS Bracket
45mm inner diameter hole.
SIMPTOMS
FOR REPLACAMENT
ABS light on dashboard,
rusted or disintegrated ABS plate, ABS sensor hanging loose. Sometimes the
plate is rusted away to the point where it is completely missing. This will
allow the sensor to sit in the right place to detect the magnetic ABS ring.
The problem
It is very common for
ABS plates to rust away, disconnecting it from the ABS sensor. The ABS plates
that sit over the wheel hub corrode and disintegrate over time, thus reducing
the connectivity to the ABS sensor and generating an ABS fault code. These
plates are not available to buy separately as they are built into the rear axle
and Renault garages will charge over £1000 for a new axle plus labor. Even
scrap yards are not willing to sell the plates separately as they can make more
money selling the complete axles and it is hard to find ABS plate in good
condition.
OUR
SOLUTION
· Install our replacement improved design ABS plate to last the lifetime of
the vehicle
· Our own design ABS plates are a much more cost-effective solution to this
common and simple issue.
· Constructed of zinc-plated steel to prevent any corrosion, be wary of
other sellers, as these will only fail again.
· The brackets are a simple press fit on to the shaft.
FITS
THESE MODELS
Centre diameter 45mm:
·
Renault
Espace IV (2001-2009)
·
Renault
Laguna II (2002-2009)
·
Renault
Grand Scenic II (2002-2009)
·
Renault
Megane III (2007-2018)
·
Renault
Scenic III (2007-2018)
·
Renault
Grand Scenic III (2007-2018)
·
Renault
Laguna III (2007-2018)
Associated part numbers:
430008639R
To be
sure of compatibility check size- will fit models with a 36mm nut retaining the
brake disc. The centre diameter of this piece is 45mm to fit 45mm shaft.
Please note there are two sizes of ABS plates
available (40mm & 45mm). If you cannot see your vehicle listed above it is
likely you need the 40mm. If unsure, please contact us to find out which size
your vehicle needs.
YOU WILL
RECEIVE
1 x ABS plate with 45mm centre bore.
Please note: Two are required if you need the part
for both sides of rear beam.