Friendly Reminder

A: The item price or the shipping cost is not including the customs duties, taxes and charges. These fee are the buyer's responsibility.

B: About the taxes rate, it depends on the local customs taxes policy. You can check with your country's customs offical website or local customs office to know how much the additional taxes will cost. Thanks for your cooperation!

Specifications:

Work mode:  HR (hair removal) mode, SR (skin rejuvenation) mode

Operating handle Lamp Type:  two ,one for hair removal, one for skin rejuvenation 

Spectral range: broad spectrum 

Spectral area: 530nm~1100nm (SR) / 650nm~1100nm (HR)

Operating head area: 4.4 cm * 1.6 cm

Energy density: 0~7J / cm2 of

Pulse number: 2 (HR) / 5 (SR)

Level range: 1~10, step 1

Power supply: AC 100V-240V, 50Hz / 60Hz in

Rated input power: 150W

Package Includes: 

1x Host machine & handle

1* HR Head

1* SR Head

1x Operation Guide & CD

1x Power Cable

1x Laser Resistant Glasses

How does it work?

With Selective pyrolysis and thermal effect principle, IPL Intense Pulsed Light  produces a high intensity flash of filtered light from the applicator head, which has been placed in contact with the skin. The energy from the light source is absorbed by the pigment melanin, which is the chromophore, which gives hair its color. the hair rapidly absorbs this filtered light and transfers it to the surrounding cells that in turn are converted into heat. The heating denatures the cells making them incapable of producing further hair growth.

How to use: 

1. Clean skin;

2. Start equipment and adjust relative energy level;

3. We advise users to wear goggles;

4. HR mode:first make test on skin with no hair: if skin turns a little red and  a little heat, it means the energy level you set is available, then you can  remove hair;

5. SR mode:first make test on skin under jawbone: if kin turns a little red and a little heat, it means the energy level you set is available, then you can treat with face from the bottom up;

6. Make treatment on entire parts; During treatment watch skin's reflection for adjusting in time;

7. Clean treated parts after treatment;

8. Treated skin needs moisturizing and avoid sunshine

Warm Tip:

1) Adjust energy level

a)  Adjust energy level from low to high:Don't adjust much for one time;

b)  Test before operation:watch whether the shot is normal before treatment;

c)  Deep color skin shall use low energy level;

2) Note during operation

a)Long hair can absorbs more light energy and this may hurt skin. So  before hair removal, cut off the longer hair(leave hair 2~3mm long);

b)Forehead, upper lip, chin -Skin is very thin, so use low energy level; you may feel a little pain during hair removal;

c)Make the tip fully touch skin to ensure skin absorb enough light hand heat; 

d)During HR operation mode, delay between two treatments shall be 30s

Note: If the HR/ SR head can't work normally, pls reset it.

1. press "+" , "-" button, and then press " start" button for 5~6 seconds, and then you will hear a sound like" wongwong", and after sound" di" , you can loose your fingers.

2. After 2~3 seconds sounds, and then you can restart it with HR/SR to check it again. 

If you still don't know how to operate, pls contact us then we can send you the video. Thanks!