***USED PARTS SALVAGE***

***SEE PHOTOS***

PCB, PV2K Low Voltage Board PN/ 98800030

***NOT TESTED***

***NO SIGNS OF BURNT OR DAMAGED COMPONENTS***

***SEE PHOTOS***

PCB, Domestic AC Board PN/ 988800041

***NOT TESTED***

***NO SIGNS OF BURNT OR DAMAGED COMPONENTS***

***SEE PHOTOS***

From PCB, INPUT BRD." PN/ 98852460:

Potentiometer, dBV Input Sensitivity 71190335R

***DC RESISTANCE TESTED***

***AVG 0.5 OHMS - 49.3 KOHMS***

Nut, dBV Input Sensitivity Potentiometer 

Connector, Input A & Input B TRS 1/4"

Nut, Input A & Input B TRS 1/4" Connector

Switch, DDT & Mode

***TESTED, NO FAULTS FOUND***

Knob, DDT Switch & Mode Switch

***SLIGHT DISCOLORATION***

Power Switch 20A 250V PN/ C1350AL

AC Power Cable w/ Switch PN/611U-10

24" 5pin To 5pin 4wire Cable

18" 5pin To 5pin 5wire Cable

24" 4pin To 4pin 2wire Cable

19" & 14" 4pin To 2x4pin 2wire Cable

4" 1wire 1pin Direct To 1pin Screw Mount Cable 

5" 7wire 8pin To 8pin Input PCB Cable

11" 7wire 8pin To 8pin Input PCB Cable

https://www.pssl.com/products/peavey-pv1200-pv-series-power-amplifier

"PV 1200 delivers sereious power with 450 Watts per side into 4 Ohms and 600 Watts per channel into 2 Ohms. This workhorse of an amplifier boasts metal TO-3 power transistors, a heavy-duty transformer and aluminum heat sinks to keep the music going all night long.

Features

1/4 inch TRS inputs

1/4 jacks and 5-way binding post speaker output terminals

Mode switch for stereo or bridge operation

LED indicators for input signal, DDT & power

Peavey's famous DDT compression system

Stereo Mode: 2 Ohms: 600* Watts RMS x 2

Stereo Mode: 4 Ohms: 450 Watts RMS x 2

Stereo Mode: 8 Ohms: 270 Watts RMS x 2

Bridge Mode-Mono: 4 Ohms: 1200* Watts RMS

Bridge Mode-Mono: 8 Ohms: 900 Watts RMS

Rated Output Power: 4 Ohms: 0.1% THD: 400 Watts RMS

Rated Output Power: 8 Ohms: 0.1% THD: 240 Watts RMS

Total Harmonic Distortion: Less than 0.07% 20 Hz - 20 kHz at rated power 4 Ohms

Frequency Response: 20 Hz to 20 kHz

Damping Factor: greater than 300

Hum and Noise:100 dB

Rack Spaces: 3 RU

Not recommended for continuous 2 ohm stereo/4 ohm bridge duty"