NMEA 2000 Converter Connector Cable Adapter For Boat Yacht Tank Gauge Marine
CX5001 NMEA 2000 Converter Connector Cable Adapter For Boat Yacht Tank Gauge Marine
CX5001 Electrical:
- Operating Voltage 9 to16 Volts(DC)
- Power Consumption <50mA
- Reverse Battery Protection
- Size 89. 6mm* 40.0mm*32.6mm
- Weight 120g
Environmental:
- Degree of Protection Ip67
- Operating Temperature -30 ~70 degree
- Storage Temperature -40 to 80°C
Features:
- NMEA 2000 Interface
- Adapts American standard(240-33 ohm)resistive sensors to NMEA 2000 Network
- Adapts European standard(0-1 90 ohm )resistive sensors to NMEA 2000 Network
- 6 Tank Types Including Fuel, Freshwater wastewater, Live Well, Oil, Blackwater
- 1 Type Rudder(0-190 ohm resistive sensors)
- Tank Number(s) Up to 4 per Tank Type
Instructions for use:
- 1. Open the lid, and to set the parameter by adjust the rotary switch. The default setting is at #1 fuel tank.
- 2. Operation method of the rotary switch:
- a. The rotary switch (0~9 )is for the selection of the type of fluid or rudder angle. Refer to the following table and turn the arrow to the corresponding no. according to the need
- b. The rotary switch (0~F) is the ID of the tank if there are several tanks.
- C. This convertor is workable either for the sensor with 0-190 ohm(European standard) or 240-33ohm(American standard).
- European standard: the corresponding tank ID of the rotary switch 0,1,2,3 is T1,T2,T3,T4.
- American standard: the corresponding tank ID of the rotary switch A,B,C,D is T1,T2,T3,T4.
- d.0-190ohm is the only parameter for setting if connecting with the rudder angle sensor.
- e. Unused numbers or letters are reserved.
Package Included: