Motorcycle Speedometer Digital Odo-meter Electric Motor Bike Tachometer Motor
Motorcycle LCD Speedometer Digital Odo-meter Electric Motor Bike Tachometer Motor
Descriptions:
- Plug & Play installation with GPS Antenna, No need mechanical speed sensor.
- Range 0~199 km/h or mph (unit switchable)
- Fast start-up GPS Location Time:
- Hot Start: <1s
- Warm Start: <10s
- Cold Start: < 38s (first power on when installation)
- Support GPS, BeiDou & GLONASS Satellites
- Support Tunnel GPS lost Odometer Compensation
- No calibration required
- Three dimensional velocity calculations accurate to 0.2km/h
Specification:
- No Mechanic Sensor, get a speed signal from GPS Satellite
- No GPS Stationary Drift with accurate algorithm
- Total Mileage Adjustable
- Trip Odometer Reset to zero
- GPS Blind Area Odometer Compensation
- Indication Light (Fuel Level, Water Level, ABS Alarm, Engine Alarm, Neutral, Left Turn, Right Turn and High Beam)
- Speed Range: 0~199km/h or MPH, unit switchable
- GPS antenna length: 300cm
- RPM Tachometer Range: 0~14000RPM
- Programmable RPM Ratio
- Reverse polarity protection and anti-fogging performance
- Working temperatures: - 40 to 85°C
- Size: 165*93*42mm
- IP65 Waterproof
Setting:
1. Quick Setting for Trip Odometer, Time
- When power on the Speedometer,
- 1) Quick Press side button, switch show TRIP, ODO
- 2) When show ODO, press and hold the side button for 8 seconds, switch unit between
- km &mile
- 3) When show TRIP, press and hold the side button for 4 seconds, TRIP odometer will
- reset to zero.
- 4) When show ODO, press and hold the side button for 4 seconds, you can enter TIME
- setting menu:
- Quick press to set value, long press 3 seconds to switch Hour & Minute
2. Configure Tachometer RPM Ratio
- Menu 1--Press & Hold Side Button, Power on the Speedometer, Hold on the button
- for 6 seconds, then the LCD will show 1 C-1850 ,then release button
- Menu 2--Press and Hold the side button again for 6 seconds, then LCD will show "2 C---02", then release button
- Menu 3--Press and Hold the side button again for 6 seconds, then LCD will show "3 C----2", then release button
"C----2" means 2 cylinder, quick press side button to switch show "C----4", which
means 4 cylinder for RPM tachometer.
Then Press and Hold button for 3 seconds to save settings
3. Change unit to km/h or MPH
- After Configure RPM tachometer ratio, then Press & Hold the side button again for 6 seconds, then LCD will show Menu 4, release button.
- Then Press & Hold the side button again for 6 seconds, then LCD will show Menu 5, release button
- Quick Press side button to switch unit between km/h and mph.
- Then Press and Hold button for 3 seconds to save settings
4. Reset Total Odometer to Zero
- After Menu 5, Then Press & Hold the side button again for 6 seconds, then LCD will show Menu 6, release button
- Quick press side button to reset Total Odometer to Zero.
Package included:
- 1* LCD GPS speedometer
- 1* GPS Antenna &Receiver
- 1* User Guide