YOU CAN SELECT FROM A CHOICE OF

Configurations

FROM DROP DOWN BOX ABOVE

Part No: HP-******

Push-in fittings as well as our straight plug-in male fittings are suited for use on plastic nylon tubes PA 6 and PA 12 as well as steel pipes or pipe sockets.

The high-pressure plug-in connectors can also be used with our CT hose lines 80 bar with pipe socket and claw slot.

Our push-in male fittings can withstand an operating and/or working pressure of up to 80 bar and can be detached without any tool and reused.

The major advantages of this technology are considerable time savings upon assembly and the push-in fittings can be used several times with an optimal result.

The excellent pressure strength enables their use as fitting with plug-in connector during the installation of centralised lubrication systems.

Our connecting elements are compatible with the designs of many renowned manufacturers of centralised lubrication systems.

AFS HP push-in fittings complement with their technical features the range of ferrule fittings offered and well-proven over years.

They are available as push-in connectors and are used by many manufacturers of centralised lubrication systems upon installation of such systems. A foresaid push-in fittings allow

• a machine manufacturer
• an automobile builder
• a superstructure maker
• an agricultural machine maker
• a wind-power plant maker

to mount lubrication systems as works installation in initial equipment with cost-effective mounting expenditure.

Thanks to the technology of a push-in fitting, the assembly time for connection to the high-pressure plastic tube or, when using the high-pressure hose line with hose socket with slot,

is considerably lesser as compared to the ferrule fitting.

It is only necessary to cut the piping to adequate length and to insert the push-in fitting.

The plastic tube or the pipe socket with slot is then instantly locked and clamped pressure-resistant.
This technology has been used for compressed-air and pneumatic systems for many years.

Now, our push-in fitting offers these advantages also in the field of high-pressure equipment for centralised lubrication systems. 

Push-in fittings can be used for high-pressure lubrication systems, grease lubrication systems or pluggable for plastic tubes or pipe sockets with slot and are ideally suited for lubrication from progressive feeder up to bearing point

BELOW IS A GUIDE

Technical specification:
 Tube types recommended: PA 6-6 and PA 12 DIN 73378 Can also be used on other tubing
Hose tolerances: +/- 0.05 pursuant to CETOP-standard
Temperature range: -20° C up to + 70°C
Pressure range: max. 80 bar

The pressure range is considerably affected by the hoses and tubes used as well as by ambient temperature

Other Option We Maybe Able to Offer

Assembly instructions:

1. Cut plastic tube to length by means of hose clippers 90° and deburr.
2. Take care that the tube is not ovally deformed.
3. Insert tube into push-in fitting up to the stop (the plastic tube offered by us has got graduation marks to facilitate this operation visually)

Dismounting:

By pressing the release collar and concurrent drawing of hose, the plastic tube can be dismounted again. After hose connection, it must be ensured that the hose does not undergo any tensile load and the minimum bending radius is respected.

Please note that our push-in fittings for centralised lubrication systems shall be installed only by skilled staff.

Copyright © by Advanced Fluid Solutions Ltd 2008-2009. All rights reserved

A Member of the British Fluid Power Distributors Association

We Also stock a variety of silicone products which will enable you to fit and make up Hose Kits for a wide range of leading performance car manufactures including:

Audi - BMW Mini - Citroen - Fiat - Ford - Honda - Hyundai - Jeep - Lancia - Mitsubishi - Nissan - Peugeot - Renault - Seat - Subaru - Vauxhall - VW Volkswagen

Please take a look at our

Ebay Shop

THANKS