• Features:

    • Condition:100% Brand New
    • Color:Black
    • Light Color: Red/Blue/Green
    • 1-6 Gear display

    Fitment:

    For Ducati Desmosedici RR   2008
    For Ducati Hypermotard ALL   2008-2015
    For Ducati Hyperstrada ALL   2013-2015
    For Ducati Monster 659   2018
    For Ducati Monster 696 ABS/NON ABS   All Years   
    For Ducati Monster 795 ABS/NON ABS   All Years
    For Ducati Monster 796 ABS/NON ABS   All Years
    For Ducati Monster 796 Corse Stripe ABS/NON ABS   All Years
    For Ducati Monster 797   All Years
    For Ducati Monster 821    2014-2020   
    For Ducati Monster 1100 ABS/NON ABS   All Years
    For Ducati Monster 1100 EVO   All Years
    For Ducati Monster 1200    2014-2020
    For Ducati Monster 1200 S    2014-2020
    For Ducati Monster 1200 R    All Years  
    For Ducati Monster 1200 R Euro 4 spec    All Years  
    For Ducati Monster Diesel    2012-2013
    For Ducati Superbike 848    2008-2013
    For Ducati Superbike 1098    2007-2009
    For Ducati Superbike 1198    2009-2017
    For Ducati Scrambler 400    2016-2017   
    For Ducati Scrambler Sixty2    2020 
    For Ducati Scrambler 800    2015-2020
    For Ducati Scrambler 1100    2018-2020
    For Ducati Streetfighter ALL    2009-2015   
    For Ducati Streetfighter V4 ALL    2020

    Installation:

    Find the BLACK, 4-pole diagnostic connector (also called as DDA) under the seat.

    - Detach the cover (cap) from the plug and connect the GFYSHIP plug.

    - Connect the red line of the GFYSHIP meter to the blue 15 above the fuse.

    - Route the cable to the mounting location along the frame.

    - Peel the green plastic off from the back of the unit, and mount the display.

    - Secure the cable with the cable ties supplied.

    Set up:

    You need to setup the module after installation. When ignition is turned on, the display counts backwards (6 to 1) indicating that the memory is clear.
    - Raise the rear wheel off the ground by using a stand, and start the engine in Neutral. (If you do not have a stand, you may setup the unit while riding. Find a long, straight road with light traffic.)
    - The display will blink “1”. Select first gear, release the clutch, and keep the RPM above idle speed. The display is blinking faster while the unit is learning the gear.
    - When the display shows “2”, select second gear. Repeat this process until all gears are thought (5 or 6). The unit is programmed and should indicate the gears correctly. Now, when ignition is turned on, the display counts forward (1 to 6) indicating that it is fully functional.

    Package Include:

    • 1 x Gear Indicator (Contains installation instructions)