Note: Please remove the white protective film at the bottom of the item before using it.
Characteristics:
Single Wall Soap Dispenser for Bathroom, Kitchen, Hotel, bar and Restaurant.
Abs Material, Durable, Rustproof and Corrosion Resistant, Look Shiny and Last for Years.
Adopt Advanced Technology Coated, Smooth and Shiny Surface, Never Fade and Easy to Scrub and Clean.
Capacity Observation Port, the Rest Can Observe Liquid, so As to Replenish It in Time.
Ergonomic T-bar Pull Level Works with Your Natural Grip for Precise Dosing with Just One Hand.
Lid Lock in the Top of the Bottle, the Inlet of Liquid Is Poured.
More Foam, less Clutter, Eliminate Bottle Clutter and Keep Shampoo and Soap Easily Accessible.
This item needs to be drilled for installation.
3*500ml Capacity, Can Be for a Long Time.
Sensitive Fluid Nozzle Allow the Fluid to Flow, Tight.
Left-hand Thread Design, Safe and Strong, Not Easy to Drop.
Specification:
Type: Soap Dispenser
Color: Silver
Material: Plastic
Product Size (L X W X H): 3* 24 X 8 X 7.5 Cm / 9.43 X 3.14 X 2.95 Inches
Included:
1 X 3*500ml Wall Mounted Soap Dispenser
1 X Base
1 X Secure Locking
1 X Pocket Install Fitting
T Pull Type Soap Dispenser Instructions
1. Remove the Mounting Plate, Use a Screwdriver to Pry Open the Base.
2. Drilling and Use the Screws to Mount the Base on the Wall As Show in the Nigure.
3. Cover the Surface Plate on the Base.
4. Insert the Back Pegs of the Dispenser into the Holes on the Wall Cover.
5. Install the Rendering.
6. Install the Base on the Bottom with Anti Theft Lock and the Key, Soap Dispenser Bottle That Can Be Locked and Not Pull out.
7. the Cap Is with a Keyhole Too, to Prevent some Rubbish into Container.
8. Since You Use the Soap Dispenser at the Soap Liquid, Follow the Following Steps.
(1) Fill 100ml Water into the Container.
(2) Pull and Hole the T-bar About 5 Seconds, You Should See some Bubbles Released into the Water up.
(3) Repeat Steps (2) Four Times Slowly Until All of the Water Inside the Container Through the Pump Was Completed Ruled out.
Put the Remaining Water in the Container Drained and Then Fill Soap Liquid.
1. Remove the mounting plate, use a screwdriver to pry open the base.
2. Drilling and use the screws to mount the base on the wall as show in the nigure.
3. Cover the surface plate on the base.
4. Insert the back pegs of the dispenser into the holes on the wall cover.
5. Install the rendering.
6. Install the base on the bottom with anti theft lock and the key, soap dispenser bottle that can be locked and not pull out.
7. The cap is with a keyhole too, to prevent some rubbish into container.
8. Since you use the soap dispenser at the soap liquid, follow the following steps.
(1) Fill 100ml water into the container.
(2) Pull and hole the T-bar about 5 seconds, you should see some bubbles released into the water up.
(3) Repeat steps (2) four times slowly until all of the water inside the container through the pump was completed ruled out.
Put the remaining water in the container drained and then fill soap liquid.
- We maintain high standards of excellence and strive for hundred percent customer satisfaction. Feedback is very important to us. We hope that you contact us immediately before you give neutral or negative feedback, so that we can address your concerns. It is impossible to address issues if we do not know about them!
