- Condition: 100% new
- Color: Black
- Material: Metal & Plastic
- Size: As picture shows
- Video Cable Length: approx. 600 cm(236.22 inch)
- Power Supply Cable Length: approx. 92 cm(39.37 inch)
- Image Sensor: 1/4 inch color CMOS pc1030
- TV system: NTSC / PAL
- Effective Pixels: 628xRGBx582=365496 pixels
- Resolution: 420 TV lines
- Video format: PAL format / NTSC standard (automatic switching)
- Dynamic Range: > 63.5db
- Signal to noise ratio:> 45.6db
- Lens angle: 170 degrees
- Sensor area: 5.961mm X 4.276mm
- Video output: 1 Vp-p, 75 ohms
- Waterproof: IP68
- Minimum illumination: 0.2lux
- Image Pipe Features: Automatic Exposure, AWB, AGC, Automatic Flicker Detection and Elimination
- Item included:
1 x Rear View Camera
1 x 6m Camera Video Cable
1 x 1m Power Cable
2 x Screws
1 x User Manual
- Compatible With: fit for Universal
-
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
Product Dimension:
Feature:
1) 100% brand new and high quality.
2) Water-proof, shock-proof and anti-jamming functions.
3) Compact design and easy to install.
4) Low illumination level, it can work within 3 meters at night and other dark environments.
5) Connect to any type of monitor with a composite yellow RCA jack for crystal clear resolution mounted inside will fit into most vehicle key holes, no other installation needed.
6) 120-170 degree wide viewing angle.
7) IP68 waterproof function, can used in outdoor environment.
8) Applicable to the various brands of vehicles: cars, mini-vans, etc.
9) Camera can rotate about 90 degree.
Installation Guide:
1) Take out your stock license plate light at the back of your car.
2) Fix the camera to where the stock license plate light was.
3) Connect the built-in license plate light of the camera to where the stock license plate light was connected to get the power.
4) Connect the power of the camera to your reverse lights - red wire to positive and black wire to negative.
5) Connect the video cable of the camera to the extension cord.
6) Connect the extension cord to your car monitor.
7) You will see the images when your car is in reverse shift.
