This is MODIFIED Headlight Switch With High Quality。
It Has More POWERFUL FUNCTIONS Than The original one
Package Include:
It Has More POWERFUL FUNCTIONS Than The original one
Package Include:
- x1 Multi-function AUTO Chrome Headlight Switch with Sensor Module
-x2 spare width light fuses
Condition: New, Modified
Compatibility :
Replace OEM Part Number:
3BD941531 , 1C0941531 , 3BD941531A
Polo, Bora, Bettle, Golf MK4, Jetta MK4, Passat B5
For Skoda Model:
Fabia before 2015 (2015 year is not included)
Fabia before 2015 (2015 year is not included)
FUNCTIONS:
I. Automatic headlight
Set Switch to AUTO, lights will turns on/off automatically when Ambient brightness is Lower/Higher than the set value.
II. THREE lighting Modes
1. Tunnel mode (Reaction time:1s)
2. Normal mode (Reaction time:3s)
3. Delay mode (Reaction time:5s)
III. Coming / Leaving Home
ONLY Support Headlight
IV. Quick response
It needs less than 1second to be automatic open headlight
V. Protect your Battery
Before the car Starts, lights turn off automatically.
After the car starts, lights turn on after 3s.
POSITION of Width Light fuses:
Installation:
It is easy to install.(Only need about 10min)
set Switch to O
push knob follow the arrow, turn right about 5mm to make the knob stuck.
when the knob stuck, Pull the knob out of the headlight switch assembly.
NOTE:Gently pull out the headlamp switch assembly. If you can not pull it out,it indicates the knob is not in place.
Hold and press the buckle, Tightly plug into the switch socket first, then pull out the harness connector.
Hold the buckle with your thumb, Press harder in the order of the arrows 1->2, then you will pull out the harness connector.
Open the insurance cover of left side center console.
put the Sensitive wire from the mounting switch hole to the left of the center console.
Place the AUTO switch in the mounting position, set Switch to O
Squeeze the sensitive wire into gap of A pillar
Stick the Sensetive head in the unobstructed position Under the windshield.
Replace the insurance cover, There are three clips on the cover, After the alignment position, Hammer tightly with fist.
set Switch to AUTO, you can cover the sensetive head with something and do a test.
Installation Successfully.
Please notice that the vehicle compatible chart on eBay is not 100% accurate, but the OE# provided in our listing is correct. Searching by OE number, that's the BEST way to check if this is the RIGHT FITMENT.