Nylon Metal Ball Head Tie Rod End for Airplane Model Replacement DIY Accessories

Half Pedestal Ball Buckle:
The semi-pedestal ball head, commonly known as the ball head with a gasket, is different from the standard ball head in that the inner copper ball of the ball head has one side higher than the height of a pad, which is often used in model aircraft/climbing cars/simulation cars/drift cars /Remote the tie rod joint of the model boat.

Φ2×H6×L19mm×M2(tie rod hole)
Bottom hole size of M2 ball joint: 2mm Suitable for M2 tie rod, steel wire, rolling metal ball hole diameter: 2.0mm
 
Φ2.5×H6×L24mm×M2.5(tie rod hole)
Bottom hole size of M2.5 ball joint: 2.5mm Suitable for M2 .5 tie rod, steel wire, rolling metal ball hole diameter: 2.5mm
 
Φ3×H7×L29mm×M3(tie rod hole)
Bottom hole size of M3 ball joint: 3mm Suitable for M3 rod, steel wire, rolling metal ball hole diameter: 3.0mm
 
Short ball head buckle:

There are two kinds of standard ordinary ball head and half cushion ball head
 
Φ3×H6×L15mm×M3(tie rod hole)
Bottom hole size of M3 ball joint: 3mm length 15mm, rolling metal ball diameter: 3.0mm

 Φ3×H6×L20mm×M3(tie rod hole)
Bottom hole size of M3 ball joint: 3mm length 20mm, rolling metal ball diameter: 3.0mm