A set of 4 high quality Locking Wheel Nuts manufactured by Evo - Protect your investment by securing expensive wheels and tyres.
FOR STEEL & ALLOY WHEELS
Evo locking wheel nuts and bolts are supplied with a unique key number,
a replacement key can be obtained direct from the Manufacturer (Details
Included in box)
They have a very strong 3 pin design. This makes them very secure and hard to remove.
Approved and used by many major Car Companies
Each Nut has a stainless cap to cover the Nut head, this makes them look like a normal nut and matches your other wheel nuts.
The key uses a standard 21mm socket
Manufactured to ISO9001 QS9000 Standards.
PLEASE NOTE this set is designed as replacements, the key WILL NOT fit your current locking nuts / bolts.
Please Read Important Information: Always compare the seating and thread with the original equipment fitted, The Manufacturer Strongly recommends that each installation should be inspected during fitment and thoroughly checked after fitment (by spinning the wheel if necessary) after 200 miles or 300km use. Torque settings should be in accordance with vehicle manufacturers recommendations. If you are unsure about any aspect of fitting do not attempt to fit but contact your local dealer. Your wheel hubs or brakes may be adversely affected by wrongly fitted wheel nuts. Do not use air guns to fit.
These nuts are specified to fit the vehicle shown in the compatibility table, please note they are specified for OE (original equipment) not aftermarket wheels. If your vehicle has aftermarket wheels fitted you should seek advice from the wheel manufacturer to ensure you have the correct seating.