window lift motor
















Power Window Motors

Compatible with Mazda Models：

  • Compatible with 2004-2009 MAZDA 3 L4 2.0L/2.3L Front Left & Rear Right
  • Compatible with 2006-2010 MAZDA 5 L4 2.3L Front Left; Rear Left
  • Compatible with 2012-2015 MAZDA 5 L4 2.5L Front Left; Rear Left
  • Compatible with 2003-2008 MAZDA 6 L4 2.3L Front Left & Rear Right
  • Compatible with 2003-2008 MAZDA 6 V6 3.0L Front Left & Rear Right
  • Compatible with 2007-2012 MAZDA CX-7 2007-2012 L4 2.3L Front Left & Rear Right
  • Compatible with 2007-2012 MAZDA CX-7 2010-2012 L4 2.5L Front Left & Rear Right
  • Compatible with 2007 MAZDA CX-9 V6 3.5L Front Left & Rear Left
  • Compatible with 2008-2015 MAZDA CX-9 V6 3.7L Front Left & Rear Left
  • Compatible with 2004-2011 MAZDA RX-8 R2 1.3L Front Right

Reference Number:

  • GJ6A5958XF, G22C5958XC, D6515958XB,GJ6A5958XE，MA1356101，742-801
GJ6A-59-58X Power Window Lift Motor

Feature:

  • Perfect performance, increase security
  • Drop-in replacement for proper fit and easy installation
  • Meet OEM standard, 100% test before shipment
  • Made of stronger materials for greater stability and reliability



Window maintenance

How do I Maintain My Car's Electric Windows?

  • 1) if the window can not be completely up and down, it may be the fault of the electric window switch, if so, then replace the electric window switch.
  • 2) if it is found that the electric window motor is stuck, it should open the door decoration plate, and then spray lubricant on the inside of the motor gear of the electric window, and move up and down while spraying, so that a very small part can also be sprayed with lubricant.
  • 3) check the rubber parts at both ends of the window glass guide groove. When the sliding condition of the window glass and the guide groove is poor, the rubber protective agent can be sprayed.
  • 4) when the rubber strip in the window glass guide groove is hardened or stained, so that the window glass lifting is not smooth or stuck, the dirt should be cleaned, and then the lubricating oil is sprayed in the window glass guide groove for lubrication and keep the window clean.

nifeida motor lift

Installation Instructions

  • Disconnecting the Window from the Motor Remove the interior door panel. Gently remove the plastic door cover. Locate the window mounting bolts. Move the window if necessary to access the bolts. Remove the bolts while a friend supports the window. Raise the window up into the door frame. Use masking tape to secure the window in place.
  • Disconnecting the Motor and Regulator Remove the window regulator bolts. Locate and remove the window motor mounting bolts. Disconnect the motor wiring harness connector. Remove the motor and regulator through the access port. Connect the regulator to the new motor.
  • Installing a New Power Window Motor Slide the new motor and regulator back into place. Replace the mounting bolts. Reconnect the electrical connector. Remove the masking tape and lower the window back down. Insert the window mounting bolts. Reinstall the plastic liner and interior panel.