You May Like

  • description
    •

    Aa-autoparts-usa

    Best choice of motor parts

    Fit For 2001 2002 2003 2004 Toyota Tacoma Headlights Assembly Set Black

    Features:

    100% Brand New

    DOT & SAE for street legal

    Great Replacement or upgrade for factory headlights

    Bulbs: H4 (Not Included)

     


    Replacement OEM part numbers: 
    OE # 81110-04110
    OE # 81620-04080
    OE # 81610-04080
    OE # 81150-04110

     


    Fit For:

    For 2001-2004 Toyota Tacoma models only


    Package Includes:
    Pair Headlight Assembly Left + Right

     


    Installation:

    Install:
    1.Undo the screws, clips, or retainer springs that hold the headlight in place.
    2.Disconnect the wiring from the assembly.
    3.Detach the headlight from the vehicle to replace it with a new one.
    4.Fit in the new headlight assembly.
    5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.
    6.Reconnect the wiring that was unplugged from the assembly.
    7.Put back the grille and other components that you removed. Seal them back into place.
    8.Test the new assembly.

     

     

    Adjust：
    Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.


    1. 【Find the adjustment screws】Firstly, locate the adjustment screws on your vehicle.


    2. 【Adjust the headlights individually】The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.


    3. 【Adjust the vertical field】The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.


    4. 【Adjust the horizontal field】The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.


    5. 【Test your results】

     


    Item Specifics
    California Prop 65 Warning This product can expose you tochemicals including dehp, which are known to the State of California to cause cancer and birth defects or other reproductive harm.
    Non-Domestic Product No
    Modified Item No
    Custom Bundle No
    Other Part Number TO2502136, TO2503136
    Interchange Part Number 8115004110,881150-04110,81110-04110
    Warranty 5 Year
    Bulbs Included No
    Assembly Type Composite
    Certifications DOT
    Fitment Type Direct Replacement
    Housing Color Black
    Placement on Vehicle Front
    Headlight Style Factory
    Manufacturer Part Number NIS066942
    Brand KAC
    High Beam / Low Beam Bulb Type H4 Bulbs (Bulb Not Included)
    Turn Signal Bulb Type 4357A Bulbs (Bulb Not Included)
    Package Include Driver & Passenger Side
    Material ABS Plastic Housing / Polycarbonate Lens
    UPC 909764066942

    Payment
    Welcome to aa-autopart-usa’s eBay Store.
     
     
    We specialize in automotive car parts and is the No.1 industry distributor for affordable and quality products. Our inventory is one of the largest and been consistently selling on eBay for a decade. You can tell by our feedback that we’ve been doing this for many years and have the expertise to accommodate your every needs.
    Shipping
    Double check shipping address.
     
    We are not responsible for any changes to address after item has been shipped.
     
    Transaction will be held until a full shipping amount received.
     
    Customer assumes shipping charges incurred in shipping to undeliverable address.
    Please use Shipping & Payments tab on top of page for shipping details for your location.
     
     
    International buyers are responsible for all customs duties, taxes, and other applicable fees incurred by the country's customs/border regulations. Please contact customs for more information.
     
    Some of the packages cannot be delivered to a PO Box. Customer is responsible to ensure PO Box address given is deliverable by the shipping company. Package will be held until a valid physical address is provided.
    Returns
    Standard Order Processing time:
     
    All items will ship within 24 hours (Monday - Friday).
    Payment cleared/received on Friday will be shipped on the next business days (Monday or Tuesday)
     
    We are not responsible for carrier transit time. This information is provided by the carrier and excludes weekends and holidays. Note that transit times may vary, particularly during peak periods or in climate weather conditions, and that delivery times frames will need to be extended for any processing time frames in excess of 1-2 business days.
     
     
    International Shipping:
    International buyers are responsible for possible customs fees, brokerage fees or duty fees. We would appreciate for understanding of tracking number would not be updated in between the city of departing in the U.S. and the city of destination.
    Contact Us
    24 Hours Online
     
    If you have any question,please don't be hesitated to contact us if you have any question.We always strive for 100% customer satisfaction. With your support, we will make a progress everyday, we always grow up with you.

    Aa-autoparts-usa

    Best choice of motor parts
    Shop Category
     Store Home
     Air & Fuel Delivery System
     Interior Parts & Accessories
     Cooling System
     Air Conditioning & Heating
     Steering System
     Lighting System
     Exterior Parts & Accessories
     Other
    Hot Item
    Excellent Delivery

    content_src_url

    Help & Info
    Payment Policy
    Shipping Policy
    Return Policy
    FAQ
    About Us
    New List Item

    21-5310 For BMW E46 323i 325i 328i 330i 325Ci 2001-2003-2005 Power Steering Pump

    Item specifics

    • Condition:New
    • Part Type:Steering Pump
    • Interchange Part Number:21-5310,965310,32-41-6-756-582
    • Colour:Silver
    • Material:Metal
    • Type:power steering pump
    • Holes:As picture shows

     

    Features & Details

     

    • 【PREMIUM QUALITY】- This steering pump is made of high-quality material and maintains an excellent strength to give the parts long-term performance. It can be installed easily without using complicated tools.
    • 【FUNCTIONAL STEERING PUMP】- The power steering pump is used to converting power to the power steering fluid from the reservoir into the steering gear and keeps the wheels running in the right conditions. 
    • 【OEM PART NUMBER】- This power steering pump is designed and manufactured with OEM standard. The Part Number is 1ASPP0002712.
    • 【DIRECT REPLACEMENT】- This steering system pump is a direct replacement though it is NOT a genuine part. If your original power steering pump is failing or leaking, this replacement steering pump could be your solution. 
    • 【VEHICLE INFORMATION】- This power steering pump fits for 06-11 For honda Civic DX EX LX 1.8L L4. And please double-check the fitment information on the following product description.

     

     

     

    Fits for:

    For 2002        For bmw 325Ci   2.5L 2494CC 152Cu. In. l6 GAS DOHC

    For 2001-2005   For bmw 325xi   2.5L 2494CC 152Cu. In. l6 GAS DOHC

    For 2001-2002   For bmw 330Ci   3.0L 2979CC l6 GAS DOHC

    For 2001-2002   For bmw 330i    3.0L 2979CC l6 GAS DOHC

    For 2001-2005   For bmw 330xi   3.0L 2979CC l6 GAS DOHC

     

     

    Package Includes:

    1 x Power Steering Pump

     

     

     

    Precaution of installing Power Steering Pump

          Please pay attention to the following instructions during the Power Steering Pump installation,to avoid any loss. 
     

    •  1.  To prevent any trash and metal chips inside hydraulic pipe flowed into the pump,thus oil leak,abnormal noise and turning hard happened,steering system hydraulic pipe wasted oil should be released and cleaned.

     

    • 2.  Before assembling the high pressure connector,enough fresh hydraulic oil should be poured into the pump from high pressure oil mouth to avoid non oil absorption in low speed,then install the high pressure pipe connector and other pipeline ,all the pipeline joint should be fixed tightly without loose or oil leaking hidden trouble.

     

    • 3.  Enough steering oil should be poured into the oil reservoir,start the engine,drive the steering pump in low speed,and make sure the whole steering system full with steering oil,meanwhile,the fluid level of oil reservoir will be dropped rapidly during the oil pouring,so continuous oil filling is required to prevent air absorption in the pump.

     

    • 4.  Turning the steering wheel from one limiting position to another limiting position,and repeat 10-15times.


             Don't stop in the limiting position over 5 seconds.
              Don't use over strength in the limiting position,otherwise the fluid stays foamy.
             Repeat the above action,until no bubble leaked out.
     

    • 5.  In the process of installing pump transmission belt,tension force should be moderate,otherwise,abnormal abrasion & noise,premature damage,oil leakage & hard steering force will be shortly happened in case of too tight tension force.

     

    • 6.  All standard operation should be followed during the installing,hammer and other objects knocked is strictly forbidden.We are not responsible for any nonstandard installing damage,except the quality defect.


          Note: Abnormal noise and reservoir oil foam will be happened during the trial run unless correct venting,because of remained air stayed in steering system,affer running 10-20kms,all the remained air will be released,and the noise will be disappeared.

     
    Item Specifics
    California Prop 65 Warning Yes
    Other Part Number LF-30, 21-5310, 965310, 9900526
    Interchange Part Number 32416756582, 32411093577
    Fitment Type Direct Replacement
    Manufacturer Warranty 5 Years
    Manufacturer Part Number 32-41-6-756-582, 32-41-1-093-577
    Brand KAC
    Make For BMW (E46, E36)
    Model 01 323i, 325i, 330Ci, 325xi, 323is
    Model 02 330i, 328i, 325Ci, 330xi, 328is
    Engine 2.5L, 2.8L, 3.0L (Petrol)
    Year 1996-2005
    Housing Material Cast Iron
    Pump Type hydraumatic
    In-Line Filter Included Yes
    Reservoir Included No
    Pulley Included No
    Outlet Thread Size M16 x 1.5
    Pulley Attachement Type Press-on
    Inlet Attachement Type Hose Barb
    Outlet Attachment Type Threaded


    Welcome to aa-autopart-usa’s eBay Store.
     
     
    We specialize in automotive car parts and is the No.1 industry distributor for affordable and quality products. Our inventory is one of the largest and been consistently selling on eBay for a decade. You can tell by our feedback that we’ve been doing this for many years and have the expertise to accommodate your every needs.
    Double check shipping address.
     
    We are not responsible for any changes to address after item has been shipped.
     
    Transaction will be held until a full shipping amount received.
     
    Customer assumes shipping charges incurred in shipping to undeliverable address.
    Please use Shipping & Payments tab on top of page for shipping details for your location.
     
     
    International buyers are responsible for all customs duties, taxes, and other applicable fees incurred by the country's customs/border regulations. Please contact customs for more information.
     
    Some of the packages cannot be delivered to a PO Box. Customer is responsible to ensure PO Box address given is deliverable by the shipping company. Package will be held until a valid physical address is provided.

    Buyer return and exchange necessary conditions  
    Rule A: Unused merchandise in its original packaging.
    Rule B: The outer package is not damaged in any way.

    How to handle the return?
    1: Contact the seller first
    2: Send pictures: outer packaging, scanned labels, the item itself and complete accessories, etc.
    3: Receive a return label 
    4: Item delivery - Payment reimbursement 
    (Returns or exchanges due to the buyer's own reasons will be charged a 15% restocking fee on the original purchase, as well as return shipping or exchange shipping. (Exchanges due to shipping errors will not be charged a restocking or shipping fee.)

    Return Priority: No Returns or Exchanges
    Shipping costs are the responsibility of the buyer in the event of the following reasons 
    1: Ordering error
    2: Found a better price 
    3: Change of mind

    Please note:
    Missing accessories/quality problem/shipping damage etc 
    Please contact us first for a good solution instead of filing a return dispute.

     
     
     
    24 Hours Online
     
    If you have any question,please don't be hesitated to contact us if you have any question.We always strive for 100% customer satisfaction. With your support, we will make a progress everyday, we always grow up with you.

    NEW LISTING

    On Jun 29, 2024 at 14:49:02 PDT, seller added the following information:

    DataCaciques