1 pair (2 bulbs) of new SUPER bright high-quality LED bulbs AND  (5 bulbs) new SUPER bright high-quality LED taillight bulbs for a Deere 1023E, 1025R, 1026R, work light and many Gator . This is a very common bulb that JD used for almost all their modern equipment either as a secondary work light on the fender or rear end or as headlights such as the X700-series. They fit right into the wiring harness sockets. They ex bright, last longer, use less volts, and do not get as hot as conventional bulbs.

These modern bulbs have a font projection lens, the beam angle is 360 degrees, have a plastic base, a waterproof gasket, and an alloy body, and are over 1650 lumens each. As a point of reference, they are similar in brightness to a 40-watt halogen bulb but they do not get hot and will not melt or burn like a halogen.
 
Introduction:
Rear+Front LED bulbs
881 LED Bulbs
-Aftermarket 100% Brand New
-Base: 881
-Voltage:DC12V-24V
-Beam Angle:360°
-lumens:1200lm
-Power;100W/Set;50W/Bulb
-Color:6000K Super White
-LED Type: LED chip high power
-Beam Type:360° Beam Angle , No High Or Low Beam
-Ultra Bright LED, unique and more vivid color
-Low Power Consumption and Low Temperature
-Long-lasting Life 50000 hours
-Easy installation, just plug & play
-Faster on/off response time and vibration resistant
 
T10 Led Bulb
1.100% brand new and high quality
2.LED Type: T10
3.Material: circuit board
4.Model: T10 light source
5.Number of lamp beads: 15SMD/Bulb
6.Power: 5 (W)
7.Dimensions: as shown in the figure (mm)
8.Luminous flux: 1000LM
9.Applicable models: General
10.Color temperature:6000K
11.Color:White
 
for John Deere Original Equipment Bulb / Work Lights – R136239

DataCaciques