Car Headlight Tint Light Smoke Black 2M x 30CM Wrap Tail Fog Light Vinyl Wrap

SPECIFICATIONS:

 

100% brand new and high quality.
Less aggressive glue.
Easy to clean.
Scratch resistant
Stretchable with heat gun or hair dryer
Waterproof
Anti-UV
Perfect for car, vehicle and trailer lights, headlight, tail lights, brake lights, fog lights and glass tinting.
Removable. Use low temperature heat gun or hair dryer for removing it.
Self adhesive

30x200cm/Roll
 
Package Include
 
1x Rolls
 
 
 
 
INSTALLATIONS:
Clean applying surface thoroughly with a window cleaner and paper towels to remove dust.
Measure and cut the film leaving extra on each side.
Spray the side of glass generously with water. 
Peel of the film liner and spray the exposed adhesive with water.
Install the tinting film to glass by keeping film straight without wrinkles.
Use squeegee to remove water and bubbles out. Working from the centre to edges.
Use heat gun or hair dryer to dry it out and better effect. Squeegee allover again.

Please Note:

Please cut 10CM X 10CM smaller piece from roll to check quality and defect prior to using it. 

For the first few days after your lights are tinted they might appear cloudy, hazy, and you may see little water pockets forming underneath the film. When lights are tinted, the squeegee can only remove a certain amount of the water from between the film and the glass. As the film dries, the remaining water will form little pockets. Tint film is a porous material that allows water to evaporate, so these water pockets will simply evaporate and go away by themselves as the film fully adheres to the glass. The amount of time before your new tint will be totally dry is determined by the amount of sunlight it gets. If it’s cloudy and overcast outside, it will take longer, if it’s hot and sunny, then the film dries very quickly. With a typical installation this could take anywhere from 2 days to 15 days.
PushAuction