●Product description: Due to the application of oil stain and varnish in similar colors, the exterior case was damaged to make the best use of the wood grain.When I first received it, the exterior case was broken into pieces. '' was missing, etc., but it took time to restore to its initial condition, and although there is some wear due to the passage of time, such as the back cover being missing, the 3 dials There is also a substitute knob, and the device is in good condition. The vacuum tubes used are: High frequency amplifier tube (model number unknown / 5P socket, with T/G / socket changed from MT tube type to ST tube type, heater voltage 6,3V) / Detector tube (model number unknown / 5P socket, With T/G / Socket changed from MT tube type to ST tube type ・Heater voltage 6,3V) / 6Z-P1 (Heater voltage 6,3V) / KX-12F (Heater voltage 5V) It consists of a total of 4 ST and MT tubes, and the speakers are original large horseshoe speakers. The dials are operated from the left side of the front section as follows: ``For the regenerated variable capacitor (the rotating shaft was loose, so I restored it to its normal state) / For the main variable capacitor / Power switch.'' Regarding the other restoration work this time, ``Considering safety, replacing the power cord and speaker cord / The electrolytic capacitor was rejected due to lack of capacity, so I removed it and installed a relay lug in the empty space ``NEW 22μF 450V ×2・22μF 250V ×1・33μF 50V×1” / Small capacitor (0,1μF) and voltage adjustment resistor 500KΩ resistor were NG, so these were replaced / Sensitivity of radio wave input by adjusting the trimmer screw Optimization / Since there was no external input PU wiring, a new "external input PU cord for audio" was taken out from the back of the chassis (monaural sound shared with the radio circuit, but "CD/iPhone/record player" ・etc. (When using external input, please operate the variable capacitor to avoid interference with radio broadcast stations) / Perform oil maintenance on each rotating part of the variable capacitor, etc." The interior and exterior of the chassis have been cleaned.
The size is 38cm wide / 48cm high / 27.5cm deep, and weighs about 7kg.

◯　1inch=2.54cm(25.4mm)

Stock No. -