●Product description: This is a vacuum tube type small electric phonograph made by HRC. The exterior has been painted with oil stain and varnish, and has some signs of use and workmanship due to age, but the speaker cloth (cloth) has been renewed and replaced, and there are also 3 dial substitute knobs, and it is compact and in good condition. Consists of good equipment. ① In the description of the radio amplifier section, it says that the vacuum tubes used are 4 vintage ST tubes, UZ-57 / UY-56 / UX-12A / KX-12F, and the speaker was out of stock, so I have it on hand. A good ``output transformer & permanent type ``Sharp 6 1/2PM65'' is installed. Regarding the operation of dials, etc., from the left side of the front section, there are ``Radio (UP) - PU (DOWN) selector switch (newly installed) /// Power switch / for main variable capacitor / for reproduction variable capacitor''. In addition, regarding the main restoration work this time, ``Replacing the power cord and speaker cord with safety in mind / The electrolytic capacitor was deteriorated and was in an unacceptable condition, so I removed it and installed a relay lug in the empty space NEW The condition was restored by replacing the "22μF 250V × 3, 33μF 50V × 1" / The wiring sheathing around the antenna coil was in a bad state, so I renewed all of these / Tester inspection revealed that the ground wire inside the variable capacitor case There was a problem with the connection, so I removed it and added a new ground wire to restore the condition. / UZ-57 The "1MΩ resistor and mica capacitor" inserted into the first grid were in an NG state, so I replaced them / UZ-57 The "voltage adjustment resistor and shield capacitor" inserted into the second grid were not good, so we replaced it, performed oil maintenance on each rotating part of the variable capacitor, etc., and made it a fully functioning item. . ② In the explanation of the SP record player, which has a power frequency band of 50Hz and 78rpm, it says that the manufacturer is ``made by Victor (RP 301).'' Regarding the main restoration work, it says ``Crystal iron needle type PU was not allowed. , this time, I installed a new "iron needle magnet type PU" that was in good condition as an item on hand and restored the condition. / The power transmission pinch roller had deteriorated and was in a bad condition, so there was a clicking sound, so I replaced it with a commercially available "O Restored condition by replacing with 2 "rings" / "Power switch for turntable rotation with volume volume" and phono motor are in good condition / Renewal and replacement of each PU wiring system / Implementation of oil maintenance on each rotating part / etc. As long as it is a fully functioning item. The inside and outside of the chassis has been cleaned and there is no scratchy sound on each switch and volume system.
The dimensions are width 40cm / total height 37cm / total depth 23.5cm, total weight approximately 6Kg. (It is designed to facilitate after-sales maintenance by removing related bolts during exterior work. Also, we recommend periodic cleaning with a cleaning brush (nozzle-type vacuum cleaner)) , and about 30 iron needles. Thank you for your understanding.)
◯ 1inch=2.54cm(25.4mm)
Cost : $FREE
Stock No. -