The 4 Pin RGB connector is and fast way to extend 10mm LED strip light, no soldering required. Just slot the strip light into the connector, you can achieve stable extended light strips. It can support low or high wattage led strip light (Max 72W).
12x Gapless ConnectorsEasy tool to extend LED tape lights. | 6x L-Shape ConnectorsPerfect for right angle corner strip connection. | 2x Triangular PlateSmall helpful tool to open the connectors. | 20x Mount ClipsStrong Adhesive clip to fix the tape light when needs reinforced. |
Installation Tips
1. Make your light strips work well before installation.
2. Strip the silicone on the contact area (about 0.5cm) when used for waterproof LED light strips and redo the sealing when used outdoor.
TROUBLE SHOOTING
TROUBLES: The connected LED strip will not turn on when power is on. / One light strip shows different color from the others. What should I do?
REASON: - One or more of the four pins doesn't make good contact with the connector brass points. A bad connection between strips can change the current flow and cause strips to be dimmer than others or vary in color.
SOLUTION:
a. Open the connector lip, push the light strip in a little further or move it around to adjust the connection;
b. Reconnect with another connector;
c. Cut the light strips on the next cutting line to reconnect;
d. Contact seller for replacement if received defective products.