decolor full tone tinting color

Emulsion paint in 25 attractive colors for decorative coatings as well as for tinting emulsion and latex paints, synthetic resin plasters and similar water-based materials.

high color strength and yield
very good mixing behavior
solvent-free
plasticizer-free
very low emissions
for indoor and outdoor
weatherproof
lightfast
Wet abrasion resistance class 2 according to din EN 13300
abrasion resistant
airless sprayable

Scope of application:
decolor Vollton tinting paint is a synthetic resin emulsion paint and is suitable for the modern color design of facades and
Living rooms as well as for tinting commercially available, water-based dispersion, latex, wall and ceiling paints and also for synthetic resin plasters and plastics.

Characteristics:
• ready to use
• lightfast
• for indoor and outdoor
• matt
• Solvent-free and low emissions

Technical data:
Raw material basis: synthetic resin dispersion, calcium carbonate, pigments, water,
Additive density: approx. 1.40 g/sqcm
pH value: approx. 8.5
Gloss level: matt
Wet abrasion resistance
according to din EN 13300: Class 2
GISCODE for
Coating materials: BSW 20

Surface pretreatment:
The surface must be dry, clean, stable and free of release agents (dust, grease, etc.).
Remove poorly adhering paint and loose plaster.
Pre-treat highly absorbent, sandy and chalky surfaces with a quality primer.

Use as a solid color:
Apply with a brush, roller or a suitable spray device. For the base coat, the color can be used with max. Diluted with 10% water.
After the base coat has completely dried, apply the top coat undiluted.
At +20 °C and 65% relative humidity, the drying time is approx. 12 hours.
At lower temperatures and/or higher humidity, the drying time will be longer.
The colors marked with an * can only be used in full color for exterior painting.

Consumption:
approx. 150 – 200 ml/sqm; with a single coat – depending on the surface condition. Determine the exact consumption quantity by carrying out a test application on the object.

Use as a tinting color:
For tinting emulsion and distemper paints, synthetic resin plasters and similar water-based products.
The processing guidelines for the tinted product apply. Silicate paints only if approved by the manufacturer - the colors marked with an S are suitable for this.

Hints:
Mix different batch numbers together before use.
Depending on the dispersion used and the substrate, there may be color variations.
Do not process the object or ambient temperature below +5 °C.
Clean tools with water immediately after use. Keep out of the reach of children.
Ensure adequate ventilation during processing and drying.
In case of contact with eyes/skin, immediately rinse thoroughly with water.
EU VOC limit value for this product (Cat.: A/a, Wb) = 30 g/l (2010). VOC content of this product max.: 1 g/l.

Storage:
Store the container tightly closed and in a cool, but frost-free place.

Disposal:
Only empty containers for recycling.

Colors
ocher
Brick red
umbra
Black
Cigar brown
Chocolate brown
terracotta
Golden ocher
Topaz brown
Sunny yellow
Orange
Signal red
Gentian blue
Foliage green
White
Wine red
Ultramarine blue
Mint
Spring green
lilac
Petrol
Caramel
ivory
Purple
Violet

Safety notice:
Keep out of reach of children.
Always read the label and product information before use.