1Pc Milling Tools Z-Axis Tool Setting for Touch Plate Probe Router Mil
brand new and
and Alloy
Color:
See pictures
See pictures
These for touch plates make setting your tool height and zeroing your
Z-axis a These are fully functional in and many other
controller software. Overall diameter is 1-3/8".
Cord is approximately 4ft. long. Cord is attached to plate on
Wire and has an clip on the other to ground the spindle/router and compete the circuit.
Other end of wire is ready to be as a for touch probe into your electronics.
the wire of this tool check insturment to the tool connector of your Control board of the machine , then the control
Diameter : 3.5 for 1.38
Effective diameter： 25mm/0.98"
Thickness : 2 for 0.79
Cable length : 110 for 43.3
Quantity: 1Pc
Note: Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!