Rokuhan Z Scale R013 End Rail

Thank you for visiting the page! Ships with careful packing from Japan.

Explanation

Product introduction

Trail with ballast for track spacing 6.5mm. Nickel silver, a highly conductive material, is used for rails and other metal parts. Some of the joints that connect the stainless steel ballast to each other are made of separate parts that can be replaced immediately if damaged. The cross-sectional shape of the metal rails uses custom-made rails that are built into the "E" shape. The Z-gauge rails are extremely fine, and large layouts can reduce the speed of vehicles that run farther than the feeder because of the electrical resistance of the rails. To minimize this, the cross-sectional area of the rail is increased to the extent that it does not lose realism, and the electrical resistance is made as low as possible. Since the linear rail is provided with a power supply unit, the vehicle speed can be made uniform by feeding power to several places. A cover is attached to the power feed section, so if power is not supplied, the cover can be used to prevent loss of appearance. To improve the grip of the rubber tire attached to the wheel, the tire tread surface of the rail is designed to be slightly wider. Starting with a classic track with wooden sleepers to match older vehicles, the lineup will also include a concrete-sleeper style PC track.

2 x end rails



safety warning

none

china

need to assemble.