sharelifestyle in ebay
 
                            
  • 100% Brand New Hight Quality
  • Led strip light Wireless Control (+Mini Dimmer)
  • RF LED Wireless Remote Mini In-line Light Switch with On/Off Dimmer & Burst Mode Options
  • Suit Our LED Stable Light Strips. Tested & Works Well with Our LED Lights.
    Only 45mm x 15mm x 7mm ,Installed In-Line Without Taking Up Space
  • Features:
    This wireless In-Line switch designed specifically for our LED strip lights.Its functions included on/off ,dimmer,and has various flash and fade options that can be speed adjusted to suit all your lighting needs. It will run 5 Meters of LED strip light and good on thoes smaller lengths too.On bedroom lighting you can drop the brightness a bit .
  • Instructions for RF Wireless Remote:
    1.Turn On/ Standby - Press this key to turn on unit or switch to standby mode. Unit will turn on and restore to previous status at powering on moment.
    2.Lighting mode - Switch to lighting mode from dynamic mode.
    3.Dimmer Adjust Shortcuts - Switch to 100%, 50%, or 25% brightness lighting mode.
    4.Dynamic Mode Adjust - Switch to dynamic mode from lighting mode, or switch between different dynamic modes.
    5.Speed Adjust - Adjust playing speed of dynamic modes. Press SPEED+ to increase seed and press SPEED- to decrease. 
    6.Brightness Adjust (Dimmer) - Adjust lighting mode brightness. Press BRIGHT+ to increase brightness and press BRIGHT- to decrease. 
  • Functions for RF Wireless Remote:+
  • Dimmer & Dynamic
  • 8 Dynamic Effects
  • 10-level Dimmer
  • 256-Grade PWM
  • Speed Adjustable
  • Card Type Remote
  • Ultra Slim Design
  • Smooth Dimmer Effect
  • 1 to 1 Remote Paired
  • Auto Save Function
  • Specification:
  • Dynamic mode: 8 modes .
  • Dynamic speed level: 10 levels .
  • Lighting brightness level : 10 levels .
  • PWM grade: 256 grades .
  • Smooth dimmer effect: Yes .
  • Working voltage: DC 5~24V .
  • Output current : peak 12A .
  • Remote control mode: RF Wireless .
  • Remote frequency: 433.92MHz .
  • Remote distance : >15m at open area
    Installing for RF Wireless Remote
    1. Power Supply
    This unit accepts DC 5V to 24V power supply. The red cable should be connected to positive and black cable to negative.
    Please select proper power supply according to the LED application.
    2. LED Output
    The red cable should be connected to LED positive and black cable to negative. The peak output current is 12A, please reduce load if main unit is overheating.
    CAUTION:Do not short circuit the LED output, this may lead to permanent damage!
    3. Remote Control
    Please pull out the insulate part before using. The RF wireless remote signal can pass through barrier, so it's not necessary to aim at the main unit when operate. For proper receiving remote signal, do not install the main unit in closed metal parts. The remote battery is 3V CR2025 type, please only replace with same type battery.
  • Fast Shipping From Sydney - Not Overseas
    •  
     
     
    • 1 x Mini In-line LED Light Controller/Dimmer
    • 1x RF Wireless Remote Controller R106
    • 1 x Manual

         

        DataCaciques